Primer
Limit search
-
Spray 1K-Etch primer 400ml
Maston 1K sandable etch primer is a one-component primer also perfectly suited for polishing. The primer contains strong rust protection, has good adhesion and coverage properties, and can be painted over with most car paints, incl. water-based paints. Weldable! Instructions: Clean the surface thoroughly with impurities. Shake for 2 min. Make test patch. Spray several thin layers every few minutes. The primer using 2 layers (15-micron layer) is enough - sand after 15 min. As primer spray 4 layers (30-50 micron layer) - sand 45 min / light grinding or approx. 90 min / wet grinding. The product is suitable for milled aluminum and zinc-coated sheet and tin sheet. Steel can also be used as topcoat 3 months when layer thickness of at least 50 microns. After use, turn the bottle upside down and press the nozzle until only propellant comes out.
Read more -
Spray Aluminium & Galvanized Metal Primer 400ml
MASTON ALUMINUM & GALVANIZED PRIMER is a specially formulated primer/base coat for aluminum surfaces. It creates microscopic structure on the surface and tight bond for the top coat and resist problems of blistering, flaking, or peeling paint. This easy to use and fast drying primer forms a smooth, grey colored surface, which can be painted with any paint
Read more -
Spray Plastic Primer 400ml
Maston Plastic Primer spray is for hard indoor and outdoor plastic surfaces. Owing to its wonderful adhesion the primer could also be applied to hard-plastic parts of vehicles and plastic surfaces of furniture. Before priming check the suitability of the primer on a small surface area. Primer could be painted over with any Maston aerosol paint, excluding heat-resistant and HAMMER spray paints. [VIDEO Plastic Primer](https://www.youtube.com/watch?v=a08OdzHwt_8)
Read more -
Spray Polystyrene Primer 400ml
Maston Polystyrene Primer provides perfect protection for all polystyrene base materials. It forms a protective coating on the surface and eliminates penetration of solvents. It also smoothens the rough surface by filling the uneven structure of polystyrene. Let the surface dry around 2 hours and overpaint with any acrylic or water-based paint. Attention! Alkyd based paints might cause reaction of the surface.
Read more